torque specs

[phil walsh]

Hi! everyone, Say does anyone know where I can find torque specs for the Hudson super six? Specifically the exaust manifold. Any help would be greatly appreciated. Thanks,


phil

[Jon B]

Which year? 1929?

[phil walsh]

1928 Hudson roadster

[Geoff C., N.Z.]

I wouldn't worry too much about torquing to a specific tension on nearly 80 year-old studs. Common sense prevails when working on these beasties, and if torquing down to specified figure, you run the risk of either stripping the thread , pulling the stud out fo the block, or breaking the stud. I just do them up until they feel right. However, if you insist, the standard torque for a 3/8" manifold nut is 20-30 pounds. You can get the torque setting from the '48-'54 manuals, and most of the figures are universal for differing size nuts, studs, and bolts. I can scan the page and email it if you want.
Geoff.

[phil walsh]

Thanks much geoff.
sure any info
i can get will help. Thanks!
phil

[Geoff C., N.Z.]

Email me direct, and I'll send you the page. geoffclark@xtra.co.nz